Premium quality sealant based on acrylic dispersion that provides a long lasting, permanently flexible seal that can be overpainted when cured.

Uses: For sealing joints and filling cracks around showers, basins, kitchen fittings.

Surface Preparations: Application temperature +5°C to +40°C.

All substrates must be clean, dry, and free of grease and dust.

Application instructions: Cut the tip of the cartridge taking care not to damage the thread. Apply nozzle and cut cleanly at an angle of 45° with an opening slightly larger than the gap to be sealed. Apply using a standard sealant gun. Best results will be obtained by keeping an even pressure on the gun trigger and keeping the gun at a constant angle to the surface being sealed. Smooth down within 20 minutes of application using a welted spatula, piece of wood or wetted gloved finger. Care should be taken at this point not to saturate the surface as this will delay drying.

Cleaning: Tools should be cleaned after use with water. Sealant can be cleaned with water and soap before curing.

Limitations: Not suitable for continues exposure to water. Not suitable for PP, PE, PC, PMMA, PTFE, soft plastics, neoprene and bituminous substrates.

CAUTION:

Keep out of reach of children. Wash skin thoroughly after handling, Wear protective gloves / eye protection / face protection. Dispose of contents / container in accordance with local regulation. Safety datasheet available on request. Bathe the eye with running water for 15 minutes. If irritation persists seek medical attention

Email us at sales@dinainternational.co.uk for more information

Description

Premium quality sealant based on acrylic dispersion that provides a long lasting, permanently flexible seal that can be overpainted when cured.

Uses: For sealing joints and filling cracks around showers, basins, kitchen fittings.

Surface Preparations: Application temperature +5°C to +40°C.

All substrates must be clean, dry, and free of grease and dust.

Application instructions: Cut the tip of the cartridge taking care not to damage the thread. Apply nozzle and cut cleanly at an angle of 45° with an opening slightly larger than the gap to be sealed. Apply using a standard sealant gun. Best results will be obtained by keeping an even pressure on the gun trigger and keeping the gun at a constant angle to the surface being sealed. Smooth down within 20 minutes of application using a welted spatula, piece of wood or wetted gloved finger. Care should be taken at this point not to saturate the surface as this will delay drying.

Cleaning: Tools should be cleaned after use with water. Sealant can be cleaned with water and soap before curing.

Limitations: Not suitable for continues exposure to water. Not suitable for PP, PE, PC, PMMA, PTFE, soft plastics, neoprene and bituminous substrates.

CAUTION:

Keep out of reach of children. Wash skin thoroughly after handling, Wear protective gloves / eye protection / face protection. Dispose of contents / container in accordance with local regulation. Safety datasheet available on request. Bathe the eye with running water for 15 minutes. If irritation persists seek medical attention

Email us at sales@dinainternational.co.uk for more information